Wanting to grow trees in your backyard?
Do you want to prepare your soil to make sure that the trees will grow properly? If we talk about fertilization of the soil, the key is to make sure that we are allocating the correct quantity of nutrients and at the correct time. We need to ensure that there are enough macro-nutrients within the soil as the lack of these may result in reduced growth, small leaves and even yellowing leaves. Trees, in addition, need secondary nutrients such as phosphorus, potassium and sulphur in moderate amount. Furthermore, we ought to be aware that micronutrients are also needed to aid tree growth but in minute quantities. Most often than not, we cannot identify which nutrient is not enough for the reason that the signs may have common characteristics. The thing is that we would like to find out so as not to waste compost on a particular tree. If you are seeing some abnormalities in the coloration of your trees, you might want to examine the tree to find out what needs to be done.
Here are some techniques that you might use for tree fertilization:
- Exterior Treatment By using a spreader, you can spread the fertilizer over to the earth exterior. The good thing about this is that it is easy to do with just the minimal tree gardening tools needed. On the other hand, this process will leave a lot of chemical residue on your territory.
- Sub-surface Treatment This type of process is necessary if the tree is encircled by grass or to control the chemical exposure. In this scenario, you have to apply the fertilizer below the grass level. The reason for this is that the grass readily absorbs the nutrients as compared to the roots of the tree. This kind of technique is a necessity if excess water occurs on a frequent basis. There are two techniques that you can do then: a.Drill Hole Process – This requires puncturing holes around the trunk of the tree. The holes have to continue to the bore line. The good thing is that this will permit you putting compost sufficiently deep for the grass not to get through it but then shallow enough not to drain away more especially during rainy season.
- Liquid Injection – In this technique, you can make use of fertilizer that is already water dissolved. The benefit of this is that it gives you better distribution as well as the advantage of adding up water precisely into the root region while the drawback is that it can create a dark patch of grass.
- Foliar treatment and Tree Injection This entails spraying all with FDA accepted chemicals. This is okay but we have to keep in mind that DDT was an approved chemical by the federal law at one point. Foliar treatment is a terminology mend to put right minor elemental shortage of micronutrients. Characteristically, this works best during spring right prior to a stage of dynamic development.
For minor shortages, you can use instil and inoculations. These provide a methodical treatment and are able to be used together with insect pesticides. The major benefit that you can get out of this is that it can totally get rid of any remains outside the tree. On the other hand, you can only do this one time every year and the tree should be mature enough for the reason that this requires making holes on the tree.
Lastly, additional fertilization may not be required in trees. Bear in mind that excessive fertilization can lead leaves to exhaustion. This can also result in tress growing too fast therefore you will have to prune it often. However, for those in dry climates, you can put fertilizer in a tree but then the tree might in actuality only need watering deep down to the roots.